![background image](/i/trust/155514/trust-daash-wireless-mouse/h/trust-daash-wireless-mouse-004.png)
BAASH Wireless Mouse
- USER’S MANUAL
2
Mouse layout
- Button 1 (left mouse button, not programmable)
- Button 6 (default function = double mouse click)
- Button 3 (default function = middle click)
- Button 2 (default function = right mouse click)
- Button 4 (default function = page forward)
- Button 5 (default function = page backward)
- Mode button (click to switch between ‘Profile-1,2,3,4 and 5’)
Installation
- Place the battery in the mouse.
- Power on the mouse.
- Insert the Trust CD-ROM into your CD drive.
- Click “Run Setup.exe – Published by Trust International BV”.
- Click “Install driver”.
- Click ‘finished’ when the installation is finished.
- Connect the mouse to the USB port of the PC.
- Wait until the message ‘Your device is ready to use’ appears.
- Start the mouse configuration software (located in the taskbar).
- You can now start to configure the mouse.
- In the following part of the manual there will be refered to the ‘Apply’ function that updates the
mouse.
‘Apply’ is located in the bottom right corner of the main window.
(The mouse will stop working when it’s beeing updated. This will take a few seconds.)
The mouse can store 5 different profiles. You can instantly switch between these setups by pressing the ‘Mode’
button on the mouse.
You don’t need to click on ‘Apply’ after every single change. You can make all the changes that you want and
then click ‘Apply’ to update all changes directly to the mouse.