![background image](/i/yamaha/167266/yamaha-tdm-900-p-2002/h/yamaha-tdm-900-p-2002-084.png)
2-42
A
A
C
C
B
B
A A
C C
B B
G Route the starter motor lead under the rear frame
attaching boss section.
H Route the starter motor lead by the right side of the
battery and coolant reservoir tank.
I Pass the battery positive lead under the battery
band.
J Pass the rear turn signal light lead (right) by the right
side hole of fender.
K Route the rear turn signal light leads (right and left)
through the clamp installed with the rear fender.
Adjust the length of rear turn signal lead (left) by
folding and then bundle it.
A For the wire harness routing, use clamps to fasten
the wire harness to the outer hole of the cover 2.
B To the AI system
C Plug in the ignition coil lead terminals as shown in
the drawing (both left and right).
D For the throttle cable, the upper side should be the
return side and the lower side should be the pull
side.
E Fasten the coolant reservoir tank hose, sub wire
harness (air filter case), air intake vacuum hose to
the inner side of frame with a clamp. Attach the
clamp with its knot upward.
F Fasten the sub wire harness (air filter case) to the
inner side of frame with a clamp.
CABLE ROUTING
SPEC