16

H Pass the starter cable through

the front of the throttle cable.

I From left: #1, #2, #3, and #4

high-tension cords.

J Secure the wire harness and the

starter cable, on the harness
positioning tape, by use of this
band. The front end of the band
must be directed downward.
The harness must not deflect be-
tween the T-stud and the clamp.

K Connect the starter cable to face

at right angles to the vehicle
body with contact with the stop-
pers.

L Direct the crimping side of the

battery positive (+) lead wire
downward and connect the lead
wire.

M Connect the starter motor cable

to face outward at an angle of
about 45 degrees.

E Clamp the starter motor cable

and the negative (–) lead wire of
the battery to the seat rail, be-
tween the air cleaner mounting
bracket and the tank mounting
bracket.

F Connect the fuel sender coupler,

neutral switch coupler, pickup
coupler, and side stand switch
coupler wires above the air
cleaner.

G Thread the wire harness inser-

tion clamp onto the T-stud of the
frame.

SPEC

CABLE ROUTING