![background image](/i/zanussi/169683/zanussi-fcs-825c/h/zanussi-fcs-825c-018.png)
Return machine to it's upright position and remove the
power supply cable and the draining and inlet hose
from the hose holders on the rear of the appliance.
With a suitable spanner unscrew and remove the three
screws and their spacers on machine's rear.
The three holes must then
be plugged with the plastic
plug caps supplied in the
bag containing the in-
struction booklet, which
can be found inside the
drum.
Positioning
Install the machine on a flat hard floor. Make sure that air
circulation around the machine is not impeded by carpets,
rugs etc. Check that the machine does not touch the wall
or furniture. Level the washing machine by raising or low-
ering the two front feet. If necessary, check the setting with
a spirit level. Any necessary adjustment can be made with
a spanner. Accurate levelling prevents vibration, noise and
displacement of the machine during operation.
Caution! Never place cardboard, wood or similar
materials under the machine to compensate for any
unevenness in the floor.
Water inlet
Warning! This appliance must be connected to a
cold water supply
Caution! Before connecting up the appliance to new
pipework or to pipework that has not been used for
some time, run off a reasonable amount of water to flush
out any debris that may have collected
Caution! Do not use the hose from your previous
appliance to connect to water supply.
Connect the hose to a tap
with a 3/4” thread. Always
use the hose supplied with
the appliance.
The machine end of the in-
let hose can be turned in
any direction. Set the hose
correctly by loosening the
ring nut. After positioning
the inlet hose, be sure to
tighten the ring nut again
to prevent leaks.
The inlet hose must not be lengthened. If it is too short
and you do not wish to move the tap, you will have to pur-
chase a new, longer hose specially designed for this type
of use.
Water drainage
The end of the drain hose can be positioned in three ways:
18