![background image](/i/zyxel/147350/zyxel-omninet-lcdm/h/zyxel-omninet-lcdm-091.png)
Technical Reference for ZyXEL omni.net series
8-3
V.110 Outgoing Protocol
Use the following commands to configure V.110 outgoing calls.
AT Command
Description
ATB10
User rate follows DTE speed (see note below).
ATB13
User rate = 2400bps
ATB14
User rate = 4800bps
ATB15
User rate = 9600bps
ATB16
User rate = 14400bps
ATB17
User rate = 19200bps
ATB18
User rate = 38400bps
ATB19
User rate = 57600bps (For Japanese version only)
The highest Async V.110 user rate depends on bit 4 of [S119]. If the DTE speed is higher than the user setting,
the user rate on the table below will be used.
S119 bit 4 Setting
Highest Async V.110 User Rate
S119.4=0
19200 bps
S119.4=1
38400 bps for areas other than Japan (default).
S119.4=1
57600 bps for Japanese version only.
Table 44. V.110 Outgoing Protocol