![background image](/i/zyxel/142676/zyxel-zywall-1050/h/zyxel-zywall-1050-690.png)
Chapter 39 Device HA
ZyWALL 1050 User’s Guide
690
Use the
VRRP Group Add/Edit
screen to add or edit VRRP groups.
• You can only use interfaces that have static IP addresses. In addition, you
should set the static IP address to the IP address of the virtual router.
• You can only enable one VRRP group for each interface.
• You can only have one active VRRP group for each virtual router (VR ID).
The
Device HA Legacy Mode
Add
or
Edit
screen lets you configure a VRRP
group. To access this screen, click
Configuration > Device HA > Legacy Mode
> Add
(or
Edit
).
Figure 451
Configuration > Device HA > Legacy Mode > Add
Auto
Synchronize
Select this to get configuration and subscription service updates
automatically from the specified ZyWALL according to the specified
Interval
. The first synchronization begins after the specified
Interval
;
the ZyWALL does not synchronize immediately.
Interval
This field is only available if
Auto Synchronize
is checked. Type the
number of minutes to wait between synchronizations.
Apply & switch
to Legacy Mode
This appears when the ZyWALL is currently using active-passive mode
device HA. Click
Apply
to save your changes back to the ZyWALL and
set it to use legacy mode device HA.
Apply
This appears when the ZyWALL is currently using legacy mode device
HA. Click
Apply
to save your changes back to the ZyWALL.
Reset
Click
Reset
to return the screen to its last-saved settings.
Table 183
Configuration > Device HA > Legacy Mode (continued)
LABEL
DESCRIPTION