11
Charcoal filter (recycling version)
Activation of the alarm signal
• In Recirculation Version Hoods, the Filter Saturation Alarm must be activated on installation or
at a later date.
• Press and hold button
E
(Delay) for 5 seconds, until confirmation appears on the display:
•
C flashes twice – Activated Charcoal Filter saturation alarm ACTIVATED.
•
C flashes once – Activated Charcoal Filter saturation alarm DEACTIVATED.
BUTTON DISPLAY
FUNCTIONS
A
Displays the set speed
Turns the suction motor on and off
B
Displays the set speed
Decreases the speed of the motor
V3
→
V2
→
V1
C
Displays the set speed
Increases the speed of the motor
V1
→
V2
→
V3
D
Displays
HI
The spot flashes
Starts maximum suction speed. After 5 minutes the speed will return automatically to the one
set before. This function can be deactivated by pressing the button again (the decimal point at
the centre of the display will flash).
E
Displays the time remaining
before the hood turns off (count-
down) and the Set speed.
The spot at the bottom right
flashes
Enables automatic delayed shutdown of the appliance (Delay), with a delay that depends on
the working speed set.
Speed 1 → delay 20 minutes
Speed 2 → delay 15 minutes
Speed 3 → delay 10 minutes
The proposed delay time can be changed by pressing the button successively and selecting one
of the options available (5, 10, 15, 20, 25 and 30 minutes). At the end of the time selected the
appliance will turn off automatically. To deactivate this function, simply press the button until the
option selected is 0 or turn the motor off.
F
Turns the hob lighting system on and off
Displays
F
Indicates the need to wash the metal grease filters. The alarm is triggered after the Hood has been
in operation for 100 working hours. This indication is only visible when the motor is turned off.
To reset the alarm:
Turn the motor off and press button
D
for approximately 3 seconds, until the display turns off.
Displays
C
Indicates the need to change the activated charcoal filters, and also to wash the metal grease
filters. The alarm is triggered after the Hood has been in operation for 200 working hours. This
indication is only visible when the motor is turned off. This indication must be activated following
the procedure described in the section on maintenance of the activated charcoal filter.
To reset the alarm:
Turn the motor off and press button
D
for approximately 3 seconds, until the display turns off.
�
�
�
�
�
�
EN
