9 - EN

cancelled or selected in accordance with

the step the program is at. The door can be

opened if the water level is suitable. Laundry

may be added / taken out by opening the

door.

Child-proof lock

You can protect the appliance from being

tampered by children by means of the child-

proof lock. In this case, no change can be

made in the running program.

The machine is switched to child-lock by

pressing the 1st and 2nd auxiliary functions

from the left for 3 sec. 1st auxiliary function

light will flash continuously. To deactivate

the child-proof lock, press the same buttons

for 3 sec.

Ending the program through 

canceling

In order to cancel the selected program,

press the “Start/Pause/Cancel” button for 3

seconds. The machine starts to discharge

the water. “Wash” and “Program Finished”

lights will light up. “Start/Pause/Cancel” and

“Wash” lights will go off after discharging

process is over and the “Lid” light will start

flashing. “Lid” lamp will light up continuously

when the door is unlocked.

If the program is cancelled in the middle

of the process, “Wash” and “Program

Finished” lights will light up. The machine

can drain all the water or can take in water

for 3 times at most to cool down the clothes

and complete draining process. When the

water discharging process is completed,

the “Wash” light will go off, the “Program

Finished” light will light up and the “Lid”

light will continuously flash until the door is

unlocked.

End of program

The “Program Finished” lamp on the

program follow-up indicator will light up

when the program comes to an end. The lid

is unlocked 2 minutes later, the “Program

Finished” and “Lid” lamps will light up

continuously. The machine is now ready for

a second cycle.

If any key is pressed when the machine is

at the end of the program or if the position

of the selection knob is changed, the

“Program Finished” light will go off and only

the “Lid” lamp will remain as lit. If the door

is still locked, the “Lid” light will continue

flashing until the door is unlocked.

Press the “On/Off” button to shut down the

machine.

5 Maintenance and cleaning

Detergent Drawer

Remove any powder residue buildup in the

drawer. To do this;

1.  Press the dotted point on the siphon

in the softener compartment and pull

towards you until the compartment is

removed from the machine.

C 

If more than a normal amount of

water and softener mixture starts to

gather in the softener compartment,

the siphon must be cleaned.

2.  Wash the dispenser drawer and the

siphon with plenty of lukewarm water

in a washbasin.

3.  Replace the drawer into its housing

after cleaning. Check if the siphon is

in its original location.

Inlet water filters

There is a filter at the end of each water

intake valve at the back side of the machine

and also at the end of each water intake

hose where they are connected to the tap.

These filters prevent the foreign substances

and dirt in the water to enter into the

machine. Filters should be cleaned as they

get dirty.

•  Close the taps.

•  Remove the nuts of the water intake

hoses to clean the surfaces of the

filters on the water intake valves with

an appropriate brush.

•  If the filters are very dirty, you can

pull them out by means of pliers and

clean them.

•  Take out the filters on the flat ends of

the water intake hoses together with

the gaskets and clean thoroughly

under streaming water.

•  Replace the gaskets and filters