Operation

25

If you forget the password

You will be asked to enter the four digit 
password every time you turn on the projector. 
If you enter the wrong password, the password 
error message displays. You can retry by pressing 
Up 

5

, or if you did not record the password in 

this manual, and you absolutely do not 
remember it, you can use the password recall 
procedure.

Entering the password recall procedure

Press and hold Right

4

on the projector for 3 seconds. The projector will display 4 sets of 

coded number on the screen. Write down the number and turn off your projector. Seek help 
from the local BenQ service center to decode the number. You may be required to provide 
proof of purchase documentation to verify that you are an authorized user of the projector.

Changing the password

1.

Open the on-screen menu and go to 

Setting > Change Password

.

2.

Press Left 

3

or Right

4

.

3.

Enter the old password.

i. If the password is correct, you can go on to enter new password.

ii. If the password is incorrect, a “Password Error” message displays. Press Up 

5

 to 

try again or press Down 

6

 to cancel.

4

Enter  a  new  password.

IMPORTANT: The digits being input will display as asterisks on-screen. Write your 
selected password down here in this manual in advance or right after the password is 
entered so that it is available to you should you ever forget it.

Password: __ __ __ __

Keep this manual in a safe place.

5.

Perform one of the following 3 steps.

i. Pressing Auto to confirm.
ii. Press Up 

5

 to try again. 

iii. Press Down 

6

 to cancel the set-up and return to the on-screen menu.

6

Confirm the new password by re-entering the new password.

7.

Perform one of the following 3 steps.

i. Pressing Auto completes the procedure. 
ii. Press Up 

5

 to try again.

iii. Press Down 

6

 to cancel the set-up and return to the on-screen menu.

Password Error

Try again

Forgot password, please refer to User's manual