Maintenance

25

Maintenance

Lamp Information

Use and Replacement of the Lamp

When the Lamp Indicator lights up red or a message appears suggesting the time of lamp 
replacement, please install a new lamp or consult your dealer. An old lamp could cause a 
malfunction in the projector and in rare instances may even break.

For more detailed information, please refer to "LED Indicator Status & Illustration" on page 
28.

The Lamp and Temp indicators will light up if the lamp becomes too hot. Turn off the power

and let the projector cool for 45 minutes. If the Lamp or Temp  indicator still lights up when

turning the power on, please contact your dealer.

Lamp Replacement

To reduce the risk of electrical shock, always turn off the projector and disconnect the power

cord before changing the lamp.

To reduce the risk of severe burns, allow the projector to cool for at least 45 minutes before

replacing the lamp.

To reduce the risk of injuries to fingers and damage to internal components, use caution when

removing lamp glass that has shattered into sharp pieces.

To reduce the risk of injuries to fingers and/or compromising image quality by touching the

lens, do not touch the empty lamp compartment when the lamp is removed.

This lamp contains mercury. Consult your local hazardous waste regulations to dispose of

this lamp in a proper manner.