caso WineSafe
29
10.6 Electrical connection
In order to ensure the safe and trouble-free operation of the device, the following instructions
must be observed for the electrical connection:
•
Before connecting the device, compare the connection data (voltage and frequency) on
the rating plate with those of your electrical network. This data must agree in order that
no damages occur in the device. If in doubt, ask your qualified electrician.
•
The electrical outlet must be protected by a 16A safety cut-out switch.
•
The connection between the device and the electrical network may employ a 3 meter
long (max.) extension cable with a cross-section of 1.5 mm². The use of multiple plugs or
gangs is prohibited because of the danger of fire that is involved with this.
•
Make sure that the power cable is undamaged and has not been installed under or over
hot or sharp surfaces.
•
This unit is not designed to be installed in an RV or used with an inverter.
•
The electrical safety of the device is only guaranteed if the device is connected to a
properly installed protective conductor system. Operations using an electrical outlet
without a protective conductor are prohibited. If in doubt, have the house installation
checked over by a qualified electrician.
The manufacturer cannot be made responsible for damages that are caused by a
missing or damaged protective conductor.
11 Operation and Handing
This chapter provides you with important notices with regard to operating the device.
11.1 Operating elements and displays
The device transmits the following signal sounds as an acoustic feedback signal:
Please note
► Use the buttons and to set the temperature in the range of 5-22°C.
► Temperature recommendations: Red wine: 12°C – 16°C and white wine 6°C – 10°C.
► The display indicates the average temperature of the appliance at the moment.
If you press the power button the device starts/stops working.
When the LED lights the device is working.
You can set the temperature as your desire by pressing the button. There are buttons on the
panel “ ” and “ ” to adjust the temperature by 1°C among 5-22°C.
You can turn the interior light on or off by pressing the “Light” button.
