Инструкция для D-LINK DGS-3420-28TC, DGS-3420-28PC, DGS-3420-26SC, DGS-3420-28SC, DGS-3420-52P, DGS-3420-52T

(скачивание инструкции бесплатно)

Формат файла: PDF

Доступность: Бесплатно как и все руководства на сайте. Без регистрации и SMS.

Дополнительно: Чтение инструкции онлайн

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch Web UI Reference Guide

188

Figure 5-1 IPv4 Static/Default Route Settings window

The fields that can be configured are described below:

Parameter

Description

IP Address

This field allows the entry of an IPv4 address to be assigned to the static route. Tick the

Default

check box to be assigned to the default route.

Netmask

This field allows the entry of a subnet mask to be applied to the corresponding subnet mask
of the IP address.

IP Tunnel Name

Tick the

IP Tunnel

check box and enter the IP tunnel name used.

Gateway

This field allows the entry of a Gateway IP Address to be applied to the corresponding
gateway of the IP address.

Metric (1-65535)

Represents the metric value of the IP interface entered into the table. This field may read a
number between 1 and 65535.

Backup State

Each IP address can only have one primary route, while other routes should be assigned to
the backup state. When the primary route failed, Switch will try the backup routes according
to the order learnt by the routing table until route success. The field represents the Backup
state that the Static and Default Route is configured for.

Null Interface

Use the drop-down menu to enable or disable the null interface as the next hop.

Click the

Apply

button to accept the changes made.

IPv4 Route Table

The IP routing table stores all the external routes information of the Switch. This window displays all the external route
information on the Switch.

To view the following window, click

L3 Features > IPv4 Route Table

, as show below: