ENG56-400, ENG68-400, ENG56-600

Introduction

Please read this information guide carefully to be able to safely install, use and maintain your product.

Important Safety Advice

When using electrical appliances, basic precautions should always be followed to reduce the risk of 

fi

 re, electrical 

shock and injury to persons, including the following:

1. OVERHEATING

WARNING: In order to avoid overheating, do not cover the heater. Do not place material or garments on the heater, or 
obstruct the air circulation around the heater.  The heater carries a DO NOT COVER warning.

2. DAMAGE.

If the appliance is damaged, check with the supplier before installation and operation. 
If the supply cord is damaged it must be replaced by the manufacturer or service agent or a similarly quali

fi

 ed person 

in order to avoid a hazard.

3. LOCATION

Do not use outdoors.
Do not use in the immediate surroundings of a bath, shower or swimming pool.
Do not locate the heater immediately below a 

fi

 xed socket outlet or connection box. 

Ensure that furniture, curtains or other combustible material are positioned no closer than 1 metre from the heater. 
Although this heater conforms with safety standards, we do not recommend its use on deep pile carpets or on long 
hair type of rugs.

4. PLUG 

POSITIONING

The appliance must be positioned so that the plug is accessible.
Keep the supply cord away from the front of the heater.

5. 

USE OF OTHER CONTROLS

Do not use this heater in series with a thermal control, a program controller, a timer or any other device that switches 
on the heat automatically, since a 

fi

 re risk exists when the heater is accidentally covered or displaced.

6. UNPLUGGING 

In the event of a fault unplug the device.
Unplug the device when not required for long periods.

7. OWNER/USER

This appliance is not intended for use by children or persons with reduced physical, sensory or mental capabilities, 
or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the 
appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with 
the appliance.

8. ELECTRCITY

WARNING – THIS APPLIANCE MUST BE EARTHED.
This heater must be used on an AC ~ supply only and the voltage marked on the heater must correspond to the 
supply voltage.
Before switching on, please read the safety advice and operating instructions.

General Information

Only use 

fi

 ltered water in this appliance.

Always ensure that the appliance is sitting on a level surface.
Although this heater complies with safety standards, we do not recommend its use on deep pile carpets or on long 
hair type of rugs.

Please note: Used in an environment where background noise is very low, it may be possible to hear a sound which is 
related to the operation of the 

fl

 ame effect. This is normal and should not be a cause for concern. 

If this product experiences a power surge for whatever reason the product may cut-out. This is a normal safety feature 
and the product will resume operation after 30 seconds.
Once installed, never move this appliance or lay on its back, without draining the water from sump and water tank.
If you intend not using the appliance for longer than 2 weeks, drain the water from sump and water tank and dry the 
sump.

The water tank, sump, sump lid, tank cap and air 

fi

 lters must be cleaned once every two weeks, particularly in hard 

water areas.

The appliance should never be operated if the lamps are not working.
The lamps should be regularly inspected as described under ‘Maintenance’ and ‘Changing lamps’.

1