![background image](/i/elenberg/130777/elenberg-ctv-2065/h/elenberg-ctv-2065-039.png)
39
2) Video2 (Video2 input port) and S-Video and Y can’t connect
external input source at same time.
3) YPbPr and YCbCr input signal use the same input port.
4) Video2 input and Y input use the same input port.
Antenna connection
The input impedance of the TV antenna is 75Ω, the 75Ω, co-axial
cable connecting the VHF/UHF antenna can be connected with the
antenna socket on the rear board of the TV set. This is a 300Ω, flat
feed line as in the figure, which can be connected to the antenna
socket via a 300Ω/75Ω, impedance converter.
75Ω, co-axial cable is recommended to prevent the interference and
double image due to
the unmatched input
impedance of the
antenna. The anten-
na/ cable and power
line should not be
bundled together.
Install the wall-mounted accessories
When you open the TV box,
you will find the wall-mounted
accessories (optional) and the
TV set are separately packed
,If you want to use the wall-
mounted accessories, please
remove the TV pedestal, screw
the four step-shaped M8
screws on the back-cover’s
cupreous nut, other acces-
sories are fixed in the proper
place according to the above
fig (wall or ceiling),then hang
the TV set on it.