27

Preventing theft (Password Protect)

When the Password Protect function is activated, people who do not know the 
password cannot use the projector to project images when the power is turned 
on. Furthermore, the company logo and administrator's name that are 
displayed when the power is turned on cannot be changed. This means that the 
projector cannot be used if it is taken without authorisation, and thus serves as 
a theft-prevention feature.

When Password Protect is enabled

When the power is turned on, the password entry screen is displayed. The 
buttons shown in the frame below operate as numeric keypad buttons while 
the password entry screen is displayed.

Use the numeric keypad buttons to enter the password that has been set. If 
the password is entered correctly, projection will then start.

When "Power ON Protect" is enabled (ON)

Remote control

Numeric buttons

TIP

• If an incorrect password is entered three times in succession, the 

message "The projector’s operation will be locked." will be displayed 
for approximately five minutes, and then the projector will switch to 
standby mode. If this happens, disconnect the power plug from the 
electrical outlet and then reinsert it and turn the projector's power 
back on. A window requesting you to enter the password will be 
displayed, so enter the correct password.
If you happen to forget the password, make a note of the "request 
code: xxxx" number that appears in the Password screen and 
contact the nearest address provided in the "International Warranty 
Conditions" section of the Safety Instructions/World-Wide Warranty 
Terms booklet.

• If the above operation should happen to be repeated nine times 

without a correct password being entered, the following message will 
be displayed and the projector's power will not be able to be turned 
on.
"The projector's operation will be locked. Contact the nearest 
address provided in the "International Warranty Conditions" section 
of the Safety Instructions/World Wide Warranty Terms booklet."