![background image](/i/felisatti/150776/felisatti-sd10-8il/h/felisatti-sd10-8il-006.png)
6
of power source must agree with the voltage
• Please check if the
rated voltage of the
product is same as the rated voltage of the
battery.
Using the battery with higher rated voltage
than the rated voltage of the drill can result
in burning and damaging of the motor.
2) Attachment of the battery
Ma
k
e sure the battery is attached correctly
before you use the tool.
Ma
k
e sure the battery is attached in the body
of the tool tightly before you start operation.
When the battery is not attached tightly, it
may be fallen during the operation and cause
an injury in the top of your foot.
3)
P
olarity of the battery
When the polarity of the battery is not correct,
it may cause the trouble of the switch. Also,
the reversal of the rotating direction can bring
a dangerous situation.
4) Trial run
Before starting the w
ork,
wear protection
(goggles, safety helmet, ear plugs, protective
gloves) and run the tool in the direction
avoiding other persons to see if the tool is
operated normally.
5) An explanation of any symbols or
pictogram on the tool relevant to safe use.
EC Declaration of conformity
We declares that these products meet the
standards
EN 60745-1, EN 60745-2-2, EN 60335-1,
EN 60335-2-29, EN 55014-1, EN 55014-2,
EN 61000-3-2 and EN 61000-3-3 ( Categor
y װ )
in compliance with directives 2006/42/EC(MD),
2004/108/EC(EMC), 2006/95/EC(LVD).
5. Noise and Vibration Emissions
1) Noise and vibration
Noise emission values determined according to
EN 60745
Return waste material
temperatures over 50
cause damage
Max. 50
The battery
Return waste material The battery
temperatures over 50ºC
cause damage
Do not incinerate the
battery pack
Do not dispose of
batteries with general
refuse.
Do not incinerate the
batter
y pack
Do not dispose of
batteries with genearl
refuse.
Volts
Direct Current
No load speed
Revolutions or reciprocations
per minute
(Legally binding signature of the issuer)
Ki Hwang, Lee
Director of R&D and Quality Assurance
Other operators stayed close to you may be
Careless operating of the switch may cause a
Make
sure the battery is attached in
Wear safety helmet
Wear protective gloves
pictograms on the tool relevant to safe use
Wear goggles
Wear ear plugs
P
ower Tool
SD10,8IL
A weighted emission sound power level
[L
WA
] [dB(A)]
Uncertainty [K] [dB(A)]
103
92
3
A weighted emission sound pressure level [L
pA
] [dB(A)]
Santiago Lopes
Jordi Carbonell