![background image](/i/gmc/154537/gmc-sierra-2500hd-denali-2015/h/gmc-sierra-2500hd-denali-2015-193.png)
Black plate (14,1)
GMC Sierra Denali Owner Manual (GMNA Localizing-U.S/Canada/Mexico-
7299750) - 2015 - CRC - 6/9/14
9-14
Driving and Operating
Warning (Continued)
.
Adjust the climate control
system to a setting that
circulates the air inside the
vehicle and set the fan speed
to the highest setting. See
“
Climate Control Systems
”
.
For more information about
carbon monoxide, see
To save fuel, run the engine for only
short periods as needed to warm
the vehicle and then shut the engine
off and close the window most of
the way to save heat. Repeat this
until help arrives but only when you
feel really uncomfortable from the
cold. Moving about to keep warm
also helps.
If it takes some time for help to
arrive, now and then when you run
the engine, push the accelerator
pedal slightly so the engine runs
faster than the idle speed. This
keeps the battery charged to restart
the vehicle and to signal for help
with the headlamps. Do this as little
as possible to save fuel.
If the Vehicle Is Stuck
Slowly and cautiously spin the
wheels to free the vehicle when
stuck in sand, mud, ice, or snow.
See
“
Rocking the Vehicle to Get It
Out
”
later in this section.
The Traction Control System (TCS)
can often help to free a stuck
vehicle. See
Electronic Stability Control on
page 9-48
. If TCS cannot free the
vehicle, see
“
Rocking the Vehicle to
Get it Out
”
following.
{
Warning
If the vehicle's tires spin at high
speed, they can explode, and you
or others could be injured. The
vehicle can overheat, causing an
engine compartment fire or other
damage. Spin the wheels as little
as possible and avoid going
above 56 km/h (35 mph).
For information about using tire
chains on the vehicle, see
.
Rocking the Vehicle to Get
It Out
Turn the steering wheel left and
right to clear the area around the
front wheels. For four-wheel-drive
vehicles, shift into Four-Wheel Drive
High. Turn the TCS off. Shift back
and forth between R (Reverse) and
a forward gear, spinning the wheels
as little as possible. To prevent
transmission wear, wait until the
wheels stop spinning before shifting