![background image](/i/gorenje/151060/gorenje-mg1500tjw/h/gorenje-mg1500tjw-013.png)
12
Safety system
This appliance is equipped with a non-resettable,
current-sensitive glass fuse that cuts off the power
supply in case of motor failure to prevent
overheating of the appliance.
This system will automatically cut off the power
supply to the appliance in case of overheating.
If your appliance suddenly stops running:
1.
Pull the mains plug out of the socket.
2.
Let the appliance cool down for 60 minutes
3.
Put the mains plug in the socket.
4.
Press the switch button to turn off the
appliance.
5.
Press the circuit breaker button at the bottom
of the appliance to turn on the appliance.
Please contact you dealer of an authorized service
center if the thermostat system is activated too
often.
Mincing meat - tips and warnings
Make sure the cutting edges of the cutter unit are
pointing outwards.
Make sure the notch of the grinding disc fits
onto the projection of the cutter housing.
Never use frozen meat!
Do not overload the appliance during use by
pushing too much meat into the cutter housing.
Cut the meat into 10cm-long, 2cm-thick strips.
Remove bones, gristles and sinews as much as
possible.
Put the prepared meat on the feeding tray.
Press the on/off button to switch the appliance
on.
Use the pusher to gently push the meat into the
cutter housing.
For steak tartare, mince the meat with the
medium grinding disc twice.
Making sausages - tips and warnings
Always mince the meat first.
Let the sausage skin soak in lukewarm water for
10 minutes. Then slide the wet skin onto the
sausage horn. Do not block the air outlet
grooves of the horn.
Put the minced meat of the feeding tray. Press
ON/ OFF button to switch the appliance on.
If the skin gets stuck on the sausage horn, wet it
with some later.
Making Tomato
1. Insert the worm shaft into the cutter housing, the
plastic end first. Place the cone in the cutter
housing. Place the former on the cutter housing
and screw the ring on the cutter housing.
2.
Attach the cutter housing to the motor unit.
3. Place the tray on the upright part of the cutter
housing.
4. Now the appliance is ready for making tomato
mush.