Memory Protection
Advanced ECC
Memory Online Spare Mode (Rank Spare Mode)
Memory
One of the following
depending on Model
Type
HP SmartMemory
DDR4 Load Reduced (LRDIMM), or Registered (RDIMM)
Standard (Pre-
configured Models)
128GB (4 x 32GB) DDR4 2133MHz RDIMMs at 1.2V
64GB (4 x 16GB) DDR4 2133MHz RDIMMs at 1.2V
32GB (2 x 16GB) DDR4 2133MHz RDIMMs at 1.2V
32GB (2 x 16GB) DDR4 2133MHz RDIMMs at 1.2V
16GB (2 x 8GB) DDR4 2133MHz RDIMMs at 1.2V
16GB (2 x 8GB) DDR4 2133MHz RDIMMs at 1.2V
Maximum (LRDIMM)
512GB (16 x 32GB) up to 2133MHz at 1.2V
Maximum (RDIMM)
256GB (16 x 16GB) up to 2133MHz at 1.2V
NOTE:
HP memory from previous generation servers (DDR3) is not compatible with this server.
HP SmartMemory is required to realize the memory performance improvements and enhanced
functionality listed in this document for Gen9. For additional information, please see the HP
SmartMemory QuickSpecs at:
http://www8.hp.com/h20195/v2/GetHTML.aspx?docname=c04111535
NOTE:
LRDIMM and RDIMM are distinct memory technologies and cannot be mixed within a
server.
NOTE:
Depending on the memory configuration and processor model, the memory speed may
run at 2133MHz, 1866MHz, or 1600MHz. Please see Memory Population Table or the Online
Memory Configuration Tool at:
http://h22195.www2.hp.com/MemoryTool/Home/Legal
Network Controller
One of the following
depending on Model
One (1) 20Gb 2-port FlexFabric FLB, 10Gb 2-port HP FlexFabric FLB, or 10Gb 2-port Ethernet
FLB
NOTE:
Supports FCoE, , TCP/IP offload engine, hardware-based accelerated iSCSI, iSCSI boot,
and autosensing 10Gb/1Gb Ethernet.
NOTE:
Each port is autosensing the speed, and can interoperate with 1Gb HP BladeSystem c-
Class interconnect components. Both ports will operate at the same speed.
NOTE:
FlexFabric capabilities require the use of an HP Virtual Connect FlexFabric module.
Fibre Channel over Ethernet (FCoE) is supported with HP interconnects. Learn more at:
http://www.hp.com/go/bladesystem/interconnects
One (1) HP FlexFabric 10Gb 2-port 536FLB FlexibleLOM
One (1) HP FlexFabric 20Gb 2-port 650FLB FlexibleLOM
NOTE:
FlexibleLOMs are not compatible with prior generation c-Class server blades
Standard iLO Network Controller:
One (1) 10/100 Mbps port for the HP iLO 4 to Onboard Administrator link. The Onboard
Administrator (with 10/100/1000 Mbps) to BladeSystem link is 1Gbps
QuickSpecs
HP ProLiant BL460c Generation 9 (Gen9) Server
Blade
Standard Features
DA - 15052 Worldwide QuickSpecs — Version 1 — 9.9.2014
Page 4