This section lists some of the steps required to configure a Factory Integrated Model. To ensure only valid configurations
are ordered, HP recommends the use of an HP approved configurator. Contact your local sales representative for
information on configurable product offerings and requirements.
1. Factory Integrated Models must start with a CTO Server.
2. FIO indicates that this option is only available as a factory installable option.
3. All Factory Integrated Models will be populated with sufficient hard drive blanks based on the number of initial hard drives
ordered with the server.
4. Some options may not be integrated at the factory. Contact your local sales representative for additional information.
Step 1: Base Configuration (choose one of the following configurable models)
[Chassis]
HP ProLiant DL120 Gen9
8SFF Configure-to-order
Server
HP ProLiant DL120 Gen9
4LFF Configure-to-order
Server
HP ProLiant DL120 Gen9
Non-hot Plug 4LFF Configure-
to-order Server
SKU Number
778686-B21
778685-B21
787217-B21
Processor
1
DIMMSlots
8 DIMM slots for RDIMM, LRDIMM DDR4 Memory
Storage Controller
HP Dynamic Smart Array B140i
PCIe
3 PCIe 3.0 slots
Drive Cage
8SFF Hot Plug
4LFF Hot Plug
4LFF Non Hot Plug
Network Controller
HP Embedded Dual Port 361i Adapter Network Interface
Fans
3 hot swap fans, non redundant
Management
iLO Management (standard), Intelligent Provisioning (standard), iLO Essentials (optional)
USB
1 front, 1 internal, 2 rear
Ears
HP Thumbscrew Ears
Step 2: Choose Required Options (only one of the following from each list unless
otherwise noted)
HP Processors
Select one from Core options-Processor section below,
If one processor is desired, select one xxxxxx-L21
DDR4 speed is the maximum memory speed of the processor. Actual memory speed may
depend on the quantity and type of DIMMs installed.
For the Intel® C600 Chipset E5-2600 Series, the letter preceding the model number indicates the
Product Line (E3, E5, E7); 2600x v#, 2 = number of CPUs in a Node, 6 is socket/segment
designation, 00 = Processor SKU, x = L for low power SKUs and v# (not yet designated) = version
number.
HP Memory
Select one or more memory from Core options-Memory section below,
LRDIMM, RDIMM are all distinct memory technologies and cannot be mixed within a server.
The majority of ProLiant Gen9 servers support LRDIMM and RDIMM.
HP memory from previous generation servers are not qualified or warranted with this HP
ProLiant Server. HP SmartMemory is required to realize the memory performance
improvements and enhanced functionality listed in this document for Gen9.
If only one processor is installed, only half of the total DIMM slots are available. When
populating with two processors all DIMM slots are available.
Kits described as LP include Low Power DIMMs. For more information on ProLiant Energy
Efficient Features, see:
http://www.hp.com/go/proliant-energy-efficient
.
Depending on the memory configuration and processor model, the memory speed may run
at 2133MHz, 1866MHz, 1600MHz or 1333MHz. Please see Memory Population Table or the
QuickSpecs
HP ProLiant DL120 Generation9 (Gen9)
Configuration Information - Factory Integrated Models
DA - 15087 Worldwide QuickSpecs — Version 1 — 12.1.2014
Page 15