System Unit
Dimensions
(with bezel) 8 SFF - 1.69 x 17.11 x 23.90 inches (4.29 x 43.46 x 60.76 cm)
4 LFF - 1.69 x 17.11 x 23.90 inches (4.29 x 43.46 x 60.76 cm)
Weight
(approximate)
Maximum:
(all hard drives, power
supplies, and processors
installed)
37.44 Ib (17kg)
Minimum:
(one hard drive, power
supply, and processor
installed)
19.82 lb (9kg)
Input Requirements
Rated Line Voltage
100 to 240 VAC
Rated Input Current
For 550W Power Supply:
6.7 A (at 100 VAC)
3.3 A (at 200 VAC)
Rated Input Frequency
47 to 63 Hz
Rated Input Power
For 550 W Power Supply:
< 670 W (at 100 VAC),
< 660 W (at 200 VAC),
BTU Rating
Maximum
For 550 W Power Supply:
2201 BTU/hr (at 100 VAC),
2153 BTU/hr (at 200 VAC)
Power Specifications
To review typical system power ratings use the Power Advisor which is
available via the online tool located at URL:
http://www.hp.com/go/proliant-energy-efficient
or
http://www.hp.com/go/hppoweradvisor
- Click on the system of interest.
Example: DL120 Gen9- Follow the instructions of the next screens.
Power Supply Output
Rated Steady-State
Power
For 550 W Power Supply:
550 W (at 100 VAC),
550 W (at 200 VAC),
Maximum Peak Power
For 550 W Power Supply:
550 W (at 100 VAC),
550 W (at 200 VAC),
System Inlet
Temperature
Standard Operating
Support
10° to 35°C (50° to 95°F) at sea level with an
altitude derating of 1.0°C per every 305 m
(1.8°F per every 1000 ft) above sea level to a
maximum of 3050 m (10,000 ft), no direct
sustained sunlight. Maximum rate of change
is 20°C/hr (36°F/hr). The upper limit and rate
of change may be limited by the type and
number of options installed. System
performance during standard operating
support may be reduced if operating with a
fan fault or above 30°C (86°F).
Extended Ambient
Operating Support
For approved hardware configurations, the
supported system inlet range is extended to
be: 5° to 10°C (41° to 50°F) and 35° to 40°C
(95° to 104°F) at sea level with an altitude
derating of 1.0°C per every 175 m (1.8°F per
every 574 ft) above 900 m (2953 ft) to a
maximum of 3050 m (10,000 ft). The
approved hardware configurations for this
system are listed at the URL:
http://www.hp.com/servers/ashrae
QuickSpecs
HP ProLiant DL120 Generation9 (Gen9)
Technical Specifications
DA - 15087 Worldwide QuickSpecs — Version 1 — 12.1.2014
Page 36