HP Memory
Select one or more memory from Core options-Memory section below,
LRDIMM, RDIMM are all distinct memory technologies and cannot be mixed within a server.
The majority of ProLiant Gen9 servers support LRDIMM and RDIMM.
HP memory from previous generation servers are not qualified or warranted with this HP
ProLiant Server. HP SmartMemory is required to realize the memory performance
improvements and enhanced functionality listed in this document for Gen9.
If only one processor is installed, only half of the total DIMM slots are available. When
populating with two processors all DIMM slots are available.
Kits described as LP include Low Power DIMMs. For more information on ProLiant Energy
Efficient Features, see:
www.hp.com/go/proliant-energy-efficient
.
Depending on the memory configuration and processor model, the memory speed may run
at 2133MHz, 1866MHz, 1600MHz or 1333MHz. Please see Memory Population Table or the
Online Memory Configuration Tool at:
www.hp.com/go/ddr4memory-configurator
HP Power Supplies
Select one or more power supplies from Core Options-Power Supplies section below:
Prior to selecting a power supply option, it is highly recommended that you review your
server configuration in the HP Power Advisor tool to determine the right size power supply
for your server configuration. The HP Power Advisor is located at:
www.hp.com/go/hppoweradvisor
.
Mixing of power supplies in the same server is not supported. All power supplies must be of
the same input voltage, output rating, and efficiency rating. If non-matching power supplies
are installed, you may receive an error message and/or experience operational issues with
your server.
Step 3: Choose Additional Factory Integratable Options
HP Unique Options
Select one or more Unique options from Core options section below.
This section may contain FIO options, please see the Unique options section below.
FIO indicates that this option is only available as a factory installable option.
HP I/O Expansion
Options
Select one or more Riser Kit options from Core options section below.
To take advantage of the additional PCI slot upgrade, the second processor must be
installed.
This section may contain FIO options, please see HP I/O Expansion Options section below.
FIO indicates that this option is only available as a factory installable option.
HP Drives
Select one or more drives from Core options-HP Drives section below:
The components of a storage subsystem (e.g. the drive, the HBA/controller, firmware, and
the server backplane) should operate at the same data transfer rate or the system
bandwidth will be negotiated down to an acceptable level for all components.
Hard drives have either a one year or three year warranty; refer to the specific hard drive
QuickSpecs for details.
The HP ProLiant Gen9 Smart Storage solutions are equipped with re-designed Small Form
Factor (SFF 2.5 in) and Large Form Factor (LFF 3.5 in) hot plug carriers for HP Qualified
Hard Drives and Solid State Drives. These new carriers provide status and activity
indicators as well as caution indicators for "Do Not Remove".
HP Flexible LOM
Select a FlexibleLOM from Core options-Networking section below,
Only one FlexibleLOM can be added to the server. These options are upgradeable and can
be changed from the original configuration after the server is shipped.
For 10Gb adapters, a minimum of two Gigabytes (2 GB) of server memory is required per
QuickSpecs
HP ProLiant DL380 Generation9 (Gen9)
Configuration Information - Factory Integrated Models
DA - 15034 Worldwide QuickSpecs — Version 1 — 9.9.2014
Page 19