18 – 

English

Driving

4

If the engine is cold move the choke lever backwards to its 
end position.

5

Turn the ignition key to the start position.

6

When the engine starts release the ignition key 
immediately back to neutral position.

7

Push the choke lever gradually forward when the engine 
has started.

8

Let the engine run at moderate speed or half throttle for 3-
5 minutes before subjecting it to heavy load.

9

Set the required engine speed with the throttle control.

Starting the engine with a weak 
battery

If the battery is too weak to start the engine, it should be 
recharged.

When jump leads are used for emergency starting, follow the 
procedure below:

Connecting the jump leads

•

Connect each end of the red cable to the POSITIVE pole 
(+) on each battery, exercise care not to short circuit any 
of the ends against the chassis.

•

Connect one end of the black cable to the NEGATIVE pole 
(-) on the fully charged battery.

•

Connect the other end of the black cable to a good 
CHASSIS EARTH, away from the fuel tank and the 
battery.

IMPORTANT INFORMATION

Do not run the starter for more than about 5 seconds at a 
time. If the engine does not start, wait about 15 seconds 
before trying again.

!

WARNING! Never run the engine indoors, in 
enclosed or poorly ventilated areas. The 
exhaust fumes contain toxic carbon 
monoxide.

!

WARNING! Lead-acid batteries produce 
explosive gases. Avoid sparks, open flames 
and smoking close to batteries. Always wear 
protective glasses in the vicinity of batteries.

IMPORTANT INFORMATION

 Your Rider is equipped with a 

12-volt system with negative earth. The other vehicle must 
also have a 12-volt system with negative earth. Do not use 
your Rider battery to start other vehicles.