English

 – 19

Driving

Remove the cables in the reverse order

•

The BLACK cable is removed from the chassis and then 
the fully charged battery.

•

Finally the RED cable from both batteries.

Driving the Rider

1

Release the parking brake by first pressing down the 
parking brake pedal and then releasing it.

2

Carefully press down one of the pedals until the required 
speed is obtained. Pedal (1) is used to drive forwards, and 
pedal (2) to drive backwards.

3

Press in the lock button on the mechanical lifting lever and 
lower the cutting unit.

If the cutting unit does not lower completely, or if the 
blades do not rotate, lower the cutting unit completely 
using the hydraulic lifting lever. In order to ensure that the 
hydraulic cylinder is in the outer position, hold the lever in 
the forward position for a half to one second.

4

Select the required cutting height (1-7) with the cutting 
height lever.

It is important that the air pressure in both front wheels is 
equal, 60 kPa / 0,6 bar / 8.5 PSI, to produce an even 
cutting height.

Braking

Release the drive pedals. The machine slows and is stopped 
by the drive system. Do not use the parking brake as the drive 
brake.

Quicker braking is possible if you press down the drive pedal 
for the opposite direction.