Инструкция для HYUNDAI H-CSH402

(скачивание инструкции бесплатно)
Формат файла: PDF
Доступность: Бесплатно как и все руководства на сайте. Без регистрации и SMS.
Дополнительно: Чтение инструкции онлайн
background image

5

If unit fails to operate properly

· Carefully read the instruction to make sure the unit is being operated properly. Check the following before you take your unit to the local dealer for

repair.

SYMPTOM

POSSIBLE CAUSE

SOLUTION

The volume control regulator set in the
minimal position

Adjust sound level

Bad power connections

Check to see that all the power and speaker leads
are securely connected

No sound

The audio cassette receiver is damaged 

Take your unit to the local dealer for repair

Acoustic system cables are connected
without observance of polarity (+ or -)

Check to see that all the power and speaker leads
are securely connected

Damage speaker wire or speaker

Replace the speaker or speaker wires

Unnatural sound

The audio cassette receiver is damaged 

Take your unit to the local dealer for repair

NOTE: Good ground connections eliminate most electrical noise problems and require tight contact with the metal vehicle chassis. Remove plastics, paint or
rust for good electrical contact.

1
2
3
4
5
6
7
8
9
10
11
Оглавление инструкции
  • Страница 1 из 12
    H-CSH402 10 CM 2-WAY COAXIAL CAR SPEAKERS Instruction manual 10 2-
  • Страница 2 из 12
    Description The set of acoustic system includes: - acoustic system - metal grill 2 pcs - speaker wire 2 m - screw 8 pcs - clip 8 pcs 2m (x 8) (x 8) Important safeguards · · · · · The owner s manual contains important operating and maintenance instructions for your safety. It is necessary to refer
  • Страница 3 из 12
    · Never run the wiring on the outside of the vehicle or under it where it can be damaged by road hazards or the moving parts of the vehicle. Use existing wire channels, sills, panels and molding strips inside the vehicle to hide the wiring for safety and a neat appliance. · Make sure the wire of
  • Страница 4 из 12
    · · After cutting and drilling all holes, inspect the mounting areas for any metal burrs or rough edges. File any area that may interfere with the mounting of the speaker. Clean any metal shavings from the mounting area and check for areas in which water may enter the speaker cavity. Treat the area
  • Страница 5 из 12
    If unit fails to operate properly · Carefully read the instruction to make sure the unit is being operated properly. Check the following before you take your unit to the local dealer for repair. SYMPTOM POSSIBLE CAUSE SOLUTION No sound The volume control regulator set in the Adjust sound level
  • Страница 6 из 12
    Specification Loudspeaker one Magnet Peak output power woofer: 10 cm (4 ) Al-Plate injection cone midrange: 3 cm (1.2 ) TI-plated mylar main: ferrite 5.3 Oz magnet tweeter: neodymium 100 W Rated output power 35 W Impedance 4 hm Sensitivity 91 dB Frequency response 80-20000 Hz Dimensions 133.5 x
  • Страница 7 из 12
    : 2 - 2 (x 8) . 2 8 . 8 . ( 8) · . . · · , , , , . , (-) . 7 .
  • Страница 8 из 12
    · , ( ) · · , . , . , . , · , , . , (-) . , . · · , , · . , . , . : , , . . . · . . . · , , . . , , ). ( , ( 8 =94 , Ø =5 ).
  • Страница 9 из 12
    · , : - · ; ; ; . , , . , . · , · · , . . , . , 9 .
  • Страница 10 из 12
    · , . . · . : - ; ; . · , . , , 10 .
  • Страница 11 из 12
    (+ -) : . , , : 10 . (4 ) : 3 c (1,2 ) : 5.3 : 100 35 4 91 80-20000 133,5 63,5 0,6 / ( x x ) / 1,4 158 78 11 306 (164 ) ,
  • Страница 12 из 12