EN

26

Special wash cycles and Options

Notes: 

Optimum performance levels when using the “Sixty and Rapid” 

cycles can be achieved by respecting the specified number of 
place settings.

To reduce consumption even further, only run the dishwasher 
when it is full.

Note for Test Laboratories: 

for information on comparative EN 

testing conditions, please send an email to the following address: 

assistenza_en_lvs@indesitcompany.com

Delayed start

It is possible to delay the start time of the wash cycle 
by 

3, 6 or 9

 hours:

1:After  selecting  the  desired  wash  cycle  and  any  other 
options,  press  the  DELAYED  START  button.  the  indicator 

light will go on.

2: Select the desired delay time by pressing the Delayed 

Start button repeatedly. The wash phase (3 hours), drying 

phase (6 hours) and end (9 hours) indicator lights will go on 

in succession. 
If the Delayed Start button is pressed again, the option is 
deselected and the indicator light goes off.
3. After the selection process, the countdown will begin if 

the Start/Pause button is pressed. The selected delay-period 
indicator  light  flashes  and  the  Start/Pause  button  stops 

flashing (fixed light).

3. Once this time has elapsed, the DELAYED START indicator 

light goes off and the wash cycle begins.

The Delayed Start function cannot be set once a wash 
cycle has started.

Wash options* 

The OPTIONS may only be set, changed or reset after 
the wash cycle has been selected and before the Start/
Pause button has been pressed.

Only the options which are compatible with the type of wash 
cycle set may be selected. If an option is not compatible 
with the selected wash cycle 

(see Table of wash cycles)

, the 

corresponding symbol/LED flashes rapidly 3 times.

If an option is selected which is not compatible with another 
previously-selected option, it will flash 3 times and go off, 
while the most recently selected option will remain active.
To deselect an option which has been set by mistake, press 
the corresponding button again. 

Half load

If there are not many dishes to be washed, a half 
load cycle may be used in order to save water, 

electricity and detergent. Select the wash cycle and press 
the HALF LOAD button; the indicator light will go on. 

Press the HALF LOAD button again to deselect this option.

Remember to halve the amount of detergent.