21

EN

Advice regarding the first wash cycle

After the installation, remove the stoppers from the racks and 
the retaining elastic elements from the upper rack

 (if any).

Water softener settings

Before starting the first wash cycle, set the hardness lev-
el of 

the water from the mains supply. 

(see chapter Rinse 

aid and refined salt).
First load the softener tank with water, then introduce about 
1 kg of salt. It is perfectly normal for water to flow out.
As soon as this procedure is complete, run a wash cycle.
Only use salt that has been specifically designed for dish-
washers.
After the salt has been poured into the machine, the LOW 

SALT indicator light

*

 switches off.

If the salt container is not filled, the water softener and 

the heating element may be damaged as a result.

Technical data

Dimensions

width 59.5 cm

height 82 cm

depth 57 cm

Capacity

14

 standard place-settings

Water supply pressure

0,05 ÷ 1MPa (0.5 ÷ 10 bar)

7,25 psi – 145 psi

Power supply voltage

See appliance data plate

Total absorbed power

See appliance data plate

Fuse

See appliance data plate
This dishwasher conforms to the 

following European Community 

Directives: 

-2006/95/EC  (Low Voltage)

-2004/108/EC (Electromagnetic 

Compatibility) 

-2009/125/EC (Comm. Reg. 

1016/2010) (Ecodesign)

-97/17/EC (Labelling)

-2012/19/ CE  

Waste Electrical 

and Electronic Equipment (WEEE)

*

 Only available in selected models.

The machine has a buzzer/set of tones 

(depending  on  the 

dishwasher model

)

 to inform the user that a command has 

been implemented: power on, cycle end etc. 

The symbols/indicator lights/LEDs on the control panel/
display may vary in colour and may have a flashing or fixed 
light 

(depending on the dishwasher model)

. 

The display

*

 provides useful information concerning the 

type of wash cycle, drying/wash-cycle phase, remaining 
time, temperature etc.