Инструкция для INFINITI FX50 (2010), FX35 (2010)

(скачивание инструкции бесплатно)

Формат файла: PDF

Доступность: Бесплатно как и все руководства на сайте. Без регистрации и SMS.

Дополнительно: Чтение инструкции онлайн

PROGRAMMING TROUBLE-DIAGNOSIS

If HomeLink

姞

does not quickly learn the hand-

held transmitter information:

●

replace the hand-held transmitter batteries
with new batteries.

●

position the hand-held transmitter with its
battery

area

facing

away

from

the

HomeLink

姞

surface.

●

push and hold both the HomeLink

姞

and

hand-held transmitter buttons without inter-
ruption.

●

position the hand-held transmitter 2 to 5 in
(50 to 127 mm) away from the HomeLink

姞

surface. Hold the transmitter in that position
for up to 15 seconds. If HomeLink

姞

is not

programmed within that time, try holding
the transmitter in another position - keeping
the indicator light in view at all times.

If you continue to have programming difficul-
ties, please contact the INFINITI Consumer Af-
fairs Department. The phone numbers are lo-
cated in the Foreword of this Owner’s Manual.

CLEARING THE PROGRAMMED
INFORMATION

Individual buttons cannot be cleared, however
to clear all programming, push and hold the two
outside buttons and release when the indicator
light begins to flash (in approximately 20 sec-
onds).

REPROGRAMMING A SINGLE
HOMELINK

姞

BUTTON

To reprogram a HomeLink

姞

Universal Trans-

ceiver button, complete the following.

1. Push and hold the desired HomeLink

姞

button.

Do not

release the button until

step 4 has been completed.

2. When the indicator light begins to flash

slowly (after 20 seconds), position the
hand-held transmitter 2 to 5 in (50 to 127
mm) away from the HomeLink

姞

surface.

3. Push and hold the hand-held transmitter

button.

4. The HomeLink

姞

indicator light will flash,

first slowly and then rapidly. When the
indicator light begins to flash rapidly,
release both buttons.

The HomeLink

姞

Universal Transceiver button

has now been reprogrammed. The new device
can be activated by pushing the HomeLink

姞

button that was just programmed. This proce-
dure will not affect any other programmed
HomeLink

姞

buttons.

IF YOUR VEHICLE IS STOLEN

If your vehicle is stolen, you should change the
codes of any non-rolling code device that has
been programmed into HomeLink

姞

. Consult the

Owner’s Manual of each device or call the
manufacturer or retailer of those devices for
additional information.

When your vehicle is recovered, you will need to
reprogram the HomeLink

姞

Universal Transceiver

with your new transmitter information.

FCC Notice:

This device complies with FCC rules part 15. Op-
eration is subject to the following two condi-
tions: (1) This device may not cause harmful in-
terference and (2) This device must accept any
interference that may be received, including in-
terference that may cause undesired operation.

The transmitter has been tested and complies
with FCC and DOC/MDC rules. Changes or modi-
fications not expressly approved by the party
responsible for compliance could void the user’s
authority to operate the device.

DOC: ISTC 1763K1313

FCC I.D.: CB2V67690

Instruments and controls

2-63

췽

—

—
07/30/09—pattie

墍