Инструкция для INFINITI G37 Coupe (2010)

(скачивание инструкции бесплатно)

Формат файла: PDF

Доступность: Бесплатно как и все руководства на сайте. Без регистрации и SMS.

Дополнительно: Чтение инструкции онлайн

●

To set separate desired temperatures for
the driver and front passenger, push the
“DUAL” button, the indicator light illumi-
nates, and then turn the corresponding
temperature control dial.

●

To cancel the separate temperature set-
ting, push the “DUAL” button, the indica-
tor light turns off, and the driver’s side
temperature setting will be applied to
both the driver’s and front passenger’s
sides.

A visible mist may be seen coming from the
ventilators in hot, humid conditions as the air is
cooled rapidly. This does not indicate a mal-
function.

Heating (A/C off):

1. Push the “AUTO” button.

(The AUTO indicator light will illuminate
and “AUTO” will appear on the display.)

2. If the A/C indicator light illuminates, push

the “A/C” button.
(The A/C indicator light will turn off.)

3. Turn the temperature control dial to set

the desired temperature.

●

When the DUAL indicator light is turned
off:

– Pushing the driver’s side “AUTO” but-

ton changes both the driver’s and front

passenger’s side temperature.

– Pushing the passenger’s side “DUAL”

button changes only the front passen-
ger’s side temperature. (The DUAL indi-
cator light will illuminate and “DUAL”
will appear on the display.)

●

To set separate desired temperatures for
the driver and front passenger, push the
“DUAL” button, the indicator light illumi-
nates, and then turn the corresponding
temperature control dial.

●

Do not set the temperature lower than the
outside air temperature. Doing so may
cause the temperature not to be con-
trolled properly.

●

If the windows fog up, use dehumidified
heating instead of the A/C off heating.

Dehumidified defrosting/defogging:

1. Push the “

” button. (The indicator

light will illuminate.)

2. Turn the temperature control dial to set

the desired temperature.

●

To remove frost from the outside surface
of the windshield quickly, set the tem-
perature control and fan speed control to
their maximum position.

●

After the windshield is cleared, push the
“AUTO” button to set to the automatic
mode.

●

When the “

” button is pushed, the

air conditioner will automatically turn on
when the outside air temperature is
above 23°F (

⫺

5°C) to defog the wind-

shield. The air recirculation mode will
automatically turn off. The outside air
circulation mode will be selected to im-
prove the defogging performance.

Monitor, climate, audio, phone and voice recognition systems

4-35

췽

—

—
04/21/10—debbie

墍