Инструкция для KARCHER HDS 7/12-4M

(скачивание инструкции бесплатно)

Формат файла: PDF

Доступность: Бесплатно как и все руководства на сайте. Без регистрации и SMS.

Дополнительно: Чтение инструкции онлайн

– 5

Figure 5

Figure 6



Completely roll off the high-pressure
hose from the hose drum.



Rotate the hose drum until the screwed-
on semibowl is pointing toward the top.
Loosen all three screws and remove the
loosened semibowl.

Figure 7



Unlatch the fastening clamp for the high-

pressure hose and pull the hose out.



Route the new high-pressure hose

through the intended hose guide and

the deflection pulley at the bottom of the

appliance.



Slide the hose nipple all the way into the

knot section of the hose drum and se-

cure with the fastening clamp.



Replace the half bowl.

For connection values refer to technical
specifications



Connect the supply hose (minimum

length 7.5 m, minimum diameter 3/4“) to

the water connection point of the ma-

chine and at the water supply point (for

e.g. a tap).

Note:

The supply hose is not included.

If you want to suck in water from an exter-
nal vessel, the following modification is
necessary:

Figure 8



Remove the system care bottle.



Release and remove the cover of the

system care.



Remove water connection from the fine

filter.



Unscrew the fine filter from the pump
head.

Figure 9



Remove the system care reservoir.



Unscrew the top supply hose to the
swimmer container.

Figure 10



Connect the top supply hose at pump
head.



Replug the rinse line of the detergent
dosing valve.



Connect suction hose (minimum diame-
ter 3/4“) with filter (accessory) to the
water connection point.

–

Max. suck height: 0.5 m

Until the pump sucked in water, you should:



Set the pressure/quantity regulation at
the pump unit to maximum quantity.



Close the dosing valve for the detergent.



Danger

Never suck in water from a drinking water
container. Never suck in liquids which con-
tain solvents like lacquer thinner, petrol, oil
or unfiltered water. The sealings within the
device are not solvent resistant. The spray
mist of solvents is highly inflammable, ex-
plosive and poisonous.

Note:

Assembly in reverse order. Ensure

that the solenoid valve cable on the reser-
voir of the system care is not pinched.

–

For connection values, see technical
data and type plate.

–

The electrical connections must be
done by an electrician according to IEC
60364-1.



Danger

Danger of injury by electric shock.

–

Unsuitable extension cables can be
hazardous. Only use extension cables
outdoors which have been approved for
this purpose and labelled with a suffi-
cient cable cross section:

–

Always unwind extension lines com-
pletely.

–

The plug and coupling of the extension
cable used must be watertight.

Installing the replacement

high-pressure hose (appliances

without hose drum)

Installing the replacement

high-pressure hose (appliances

with hose drum)

Water connection

Suck in water from vessel