![background image](/i/lexmark/157140/lexmark-e352dn-e350d/h/lexmark-e352dn-e350d-063.png)
Уведомления
63
Уведомления
Обозначения
Уведомления об
электромагнитном
излучении
Federal Communications Commission (FCC)
compliance information statement
The Lexmark E350d and E352dn (4512-420 and 4512-430) have
been tested and found to comply with the limits for a Class B digital
device,
pursuant to Part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any
interference received, including interference that may cause
undesired operation.
The FCC Class B limits are designed to provide reasonable
protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the
following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
•
Consult your point of purchase or service representative for
additional suggestions.
The manufacturer is not responsible for any radio or television
interference caused by using other than recommended cables or by
unauthorized changes or modifications to this equipment.
Unauthorized changes or modifications could void the user's
authority to operate this equipment.
Note:
To assure compliance with FCC regulations on
electromagnetic interference for a Class B computing device,
use a properly shielded and grounded cable such as Lexmark part
number 1021231 for parallel attach or 1021294 for USB attach. Use
of a substitute cable not properly shielded and grounded may result
in a violation of FCC regulations.
Any questions regarding this compliance information statement
should be directed to:
Director of Lexmark Technology & Services
Lexmark International, Inc.
740 West New Circle Road
Lexington, KY 40550
(859) 232-3000
Industry Canada compliance statement
This Class B digital apparatus meets all requirements of the
Canadian Interference-Causing Equipment Standard ICES-003.
Avis de conformité aux normes de l’industrie du Canada
Cet appareil numérique de classe B est conforme aux exigences de
la norme canadienne relative aux équipements pouvant causer des
interférences NMB-003.
Примечание.
Примечания
содержат рекомендации по работе с изделием.
ВНИМАНИЕ!
Знаки
ВНИМАНИЕ!
указывают на опасность получения травм.
Предупреждение.
Предупреждения
указывают на опасность повреждения аппаратного или
программного обеспечения данного изделия.