17

ENGLISH

ASSEMBLING AND PREPARING

Mounting on a table

1   Lift and tilt the TV into its upright position on a 

table.

-  Leave a 10 cm (minimum) space from the 

wall for proper ventilation.

10 cm

10 cm

10 cm

10 cm

2   Connect the power cord to a wall outlet.

 CAUTION

y

Do not place the TV near or on sources 
of heat, as this may result in fire or other 
damage.

Securing the TV to a table

Fix the TV to a table to prevent from tilting forward, 
damage, and potential injury.
Mount the TV on a table, and then insert and 
tighten the supplied screw on the rear of the stand.
(Only 42PN45**)

  WARNING

y

To prevent TV from falling over, the TV 
should be securely attached to the floor/
wall per installation instructions. Tipping, 
shaking, or rocking the TV may cause injury.

Adjusting the angle of the TV to suit view

(This feature is not available for all models.)
Adjusting the angle of the TV to suit view
Swivel 20 degrees to the left or right and adjust the 
angle of the TV to suit your view.

20

20

20

˚

20

˚

 CAUTION

y

When adjusting the angle of the product, 

watch out for your fingers.

- Personal injury may occur if hands or 

fingers are pinched. If the product is tilted 

too much, it may fall, causing damage or 

injury.

Securing the TV to a wall 

(This feature is not available for all models.)

1   Insert and tighten the eye-bolts, or TV brackets 

and bolts on the back of the TV.

- If there are bolts inserted at the eye-bolts 

position, remove the bolts first.

2   Mount the wall brackets with the bolts to the 

wall. 

Match the location of the wall bracket and the 

eye-bolts on the rear of the TV.

3   Connect the eye-bolts and wall brackets tightly 

with a sturdy rope. 

Make sure to keep the rope horizontal with the 

flat surface.