!

!

  Hard Floor Nozzle (depending on   
  model) (13)

  • Efficient cleaning of hard floors
    (wood, linoleum, etc)

  Hard Floor Nozzle (depending on  
  model) (14)

  • You can perform cleaning at any place like  
    corner or crevice since revolution is free.

  Turbine Nozzle (depending on model) (15)

  • Cleaning turbine brush nozzle.
  • Press the button on the rear side of the   
    nozzle to separate the air cover.
  • Use the dusting brush & crevice tool to 
    vacuum clean the brush and fan.

Using All Floor nozzle and mini 

turbine nozzle
  All Floor nozzle (depend on model) (16)

  • 

The 2 position nozzle

    This is equipped with a pedal which allows   
    you to alter its position according to the type    
    of floor to be cleaned.
  • 

Carpet or rug position

    Press the pedal (     ), then brush will rotate
  • 

Hard floor position

    Press the pedal (     ), then brush will stop
    rotating.

  Mini turbine nozzle (optional) (17)

  • Mini turbine is used for stairs and other hard    
    to reach places.
  • To clean the mini turbine nozzle, remove 
    the nozzle cover:
    Remove 2 screws on the bottom and take     
    mini turbine nozzle cover off as shown.
  • Frequently clean and remove hair, string,   
    and lint build-up in the brush area.
    Failure to do so could damage to mini  
    turbine nozzle.

Using accessory nozzles
  Crevice Tool (depending on model) (18)

  Crevice tool is for vacuuming in those   
  normally hard-to-reach places such as   
  reaching cobwebs or between the cushions   
  of a sofa.

  Upholstery Nozzle (depending on  
  model) (19)

  Upholstery nozzle is for vacuuming uphol
  stery, mattresses etc.

  Dusting Brush (depending on model) (20)

  Dusting brush is for vacuuming picture   
  frames, furniture frames, books and other   
  irregular surfaces.

  NOTICE (21)

  Use accessory in the sofa mode.

Emptying dust tank (22)

  Cleaning the dust tank.
  • Open the tank cap.
  • Wash both parts with soft material.
  Gently rinse both parts under a cold running tap.

Cleaning dust tank (23)

  Push button and pull out dust tank.
  Raise dust tank cap.
  Dry fully in shade so that moisture is entirely   
  removed.

Cleaning air filter and motor safety 

filter (24)

If suction power is decreased after cleaning dust 
tank, clean air filter and motor safety filter.
Air filter and motor safety filter are located at the 
center of vacuum cleaner in the above figure.
• Open the air filter cover by pulling the air filter   
  cover lever and take out air filter.
• Separate the parts
• Wash air filter and motor safety filter with water.
• Do not wash filters with hot water.

Do not push the button when you carry the 
vacuum cleaner. If push the button, it is 
easy  to  detach  the  dust  tank  from  the 
vacuum cleaner.
Gently rinse both parts separately under a 
cold running tap until the water runs clear.
Do  not  use  detergent  or  a  washing 
machine or dishwasher.

If suction power decreases after cleaning 
dust tank, clean air filter and motor safety 

ENGLISH

- 27 -