3. Press the programmed
HomeLink
t
control in the vehicle
until the training light on the garage
door receiver turns solid (1-2
seconds). Release the HomeLink
t
control and repress to turn off the
training light.
4. Press the HomeLink
t
control
again. If the garage door activates,
the HomeLink
t
Universal
Transmitter has been trained to the
receiver.
Erasing channels
To erase all three programmed
channels:
1. Hold down the two outside
controls until the red light begins to
flash.
2. Release both controls.
Channels cannot be erased
individually, but can be
reprogrammed. Refer to
Programming
for instructions.
Controls and features
49