Installation instructions
6
1.
Unpack the machine and stretch the power cord.
2.
Take out the water tank, Screw out counterclockwise
the water tank cover, adding water. Then screw on the cover.
3.
Take out the support pole, (as shown in picture),
pull out the Pole 3, screw it clockwise into Pole 4, then pull out
the pole 2, screw it clockwise into pole3, the last pull out
the pole 1,
screw it clockwise into pole 2.
4.
Insert the assembled support pole into the hole on the
machine bodyuntil it reaches the bottom. Screw
clockwise
the snap close of thehole to fasten the support pole.
5.
Screw the Hook counterclockwise into the top of support pole (as shown in Picture 1), place the
adjustable hanger upon the hook (as shown in picture 2). Spread the hanger to reach a designed
range (as shown in Picture 3).For folding the hanger, you just need to push the button of hanger
(as shown in Picture 4).
6.
When needed, take out the rotary pants clip, fixed it into the pole 1. Pull out the pants clip
lightly and rotate 90 degrees (Clockwise or counterclockwise)