![background image](/i/olympus/25023/olympus-scan-r-acquisition/h/olympus-scan-r-acquisition-020.png)
14
Chapter 3 – The Main User Interface
Menu
.) During the autofocus process the autofocus type, Coarse / Fine AF and the autofocus quality is
shown in red in the upper left of the autofocus image.
System Status Bar. The status bar at the bottom of the main window indicates the progress of the scan
and gives an estimate for the remaining scan time. It gives also the actual well number, the total
number of wells to be scanned, the current position, the total number of positions to be scanned, the
current time-loop and the total number of time-loops to be performed, as well as the current plate
number and the total number of plates to be measured. The MT20-icon indicates if the burner of the
MT20 is switched on or off.
3.2 Display Context Menu
A right-click on a display opens a context menu that allows to select additional display settings and to
configure the multicolor representation.
Palette. Use this command to select the display mode for single channel displays.
Display Settings. Use this command to setup the color display mode. It opens the Display Settings
dialog.
Display Settings: Scaling color. Click on the Scaling color box to open a new window that allows you to
choose a new image display color (Note that this color is not used for the RGB-overlay).
Display Settings: Intensity clipping. To make automatic scaling more effective when noise or bright
impurities are present, you can define how many pixels (as a percentage of the total number of pixels)