4. Junior User Guidebook 

How to Implement the General Inspection   

After you get a new SDS5032E(V) oscilloscope, it is recommended that you should 
make a check on the instrument according to the following steps:   

1.  Check whether there is any damage caused by transportation.   

If it is found that the packaging carton or the foamed plastic protection cushion has 
suffered serious damage, do not throw it away first till the complete device and its 
accessories succeed in the electrical and mechanical property tests.   

2. Check 

the 

Accessories  

The supplied accessories have been already described in the "Appendix A: Enclosure" 
of this Manual. You can check whether there is any loss of accessories with reference 
to this description. If it is found that there is any accessory lost or damaged, please get 
in touch with the distributor of Lilliput responsible for this service or the Lilliput's 
local offices.   

3.  Check the Complete Instrument   

If it is found that there is damage to the appearance of the instrument, or the 
instrument can not work normally, or fails in the performance test, please get in touch 
with the Lilliput's distributor responsible for this business or the Lilliput's local offices. 
If there is damage to the instrument caused by the transportation, please keep the 
package. With the transportation department or the Lilliput's distributor responsible 
for this business informed about it, a repairing or replacement of the instrument will 
be arranged by the Lilliput.   

How to Implement the Function Inspection   

Make a fast function check to verify the normal operation of the instrument, according 
to the following steps: 

1.  Connect the power cord to a power source. Push down the button of the "

" 

signal on the top. 

The instrument carries out all self-check items and shows the Boot Logo. Press the 

"Utility"

 button, then, press 

H1

 button to get access to the "

Function

" menu. Turn 

the 

M 

knob to select 

Adjust

 and press 

H3

 button to select "

Default

". The default 

attenuation coefficient set value of the probe in the menu is 10X. 

2.  Set the Switch in the Oscilloscope Probe as 10X and Connect the Oscilloscope 

with CH1 Channel.   

Align the slot in the probe with the plug in the CH1 connector BNC, and then tighten 
the probe with rotating it to the right side.   

12