41
2
1
Firstly, set a channel of this flash unit, and register it on the
camera.
1 Turn the camera off and then attach this flash unit to the
hot shoe of the camera.
2 Turn on the power switch (ON).
3 Press the flash mode button (MODE) a number of times
to display P-TTL
MASTER on the LCD panel.
4 Press the setting button (SET) and rotate the
adjustment dial to display SLAVE.
5 Press the setting button (SET) to complete the setting.
6 Set a channel (CH1 through CH4) from the function
menu.
• Refer to “Using the Function Menu” (page 36) for
details on the function menu.
7 Press and hold the function button (
) to complete
the setting.
8 Turn the camera on and press the shutter release button
halfway down. The channel is registered on the camera.
• SLAVE cannot be selected while the camera’s
exposure metering timer is on (while information
relating to aperture, etc., is displayed in the
viewfinder).
Using This Flash Unit in Combination with a Built-in Flash Unit
of the Camera
Wireless mode
(SLAVE)
2
1
3
AF360FZ_540FGZ.book Page 41 Friday, December 20, 2013 6:11 PM