42
2
2
Remove the flash unit from the camera and place it in
the desired position.
• Press the flash mode button (MODE) to display P-TTL
on the LCD panel if the flash mode is set to the modes
other than P-TTL
.
3
Enable the built-in flash unit of the camera and set the
camera’s flash mode to
(WIRELESS).
4
Confirm that the flash unit and built-in flash unit of the
camera are fully charged, and take the photograph. A lamp
on the flash unit will blink.
• In P-TTL mode, flash output setting (1/1, 2/3, 1/2, and 1/3)
and flash output compensation (-4.0 to +2.0) can be
adjusted. (Refer to page 18.)
• The flash mode on the camera must be set to
(WIRELESS), otherwise this flash unit will not discharge.
• By changing the camera’s function settings, you can set
the built-in flash unit so that it is not the main flash. Refer
to the operating manual of the camera for details.
AF360FZ_540FGZ.book Page 42 Friday, December 20, 2013 6:11 PM