44
2
(Preparation of the Separated Flash Unit)
2
Set the channel of the separated (wireless) flash unit to the
same channel as the flash unit attached to the camera.
1 Place the other flash unit in the desired position.
2 Turn on the power switch (ON).
3 Press the flash mode button (MODE) a number of times
to display P-TTL
MASTER on the LCD panel.
4 Press the setting button (SET) and rotate the
adjustment dial to display SLAVE.
5 Press the setting button (SET) to complete the setting.
6 Set the same channel (CH1 through CH4) of the flash
unit attached to the camera from the function menu.
• Refer to “Using the Function Menu” (page 36) for
details on the function menu.
7 Press and hold the function button (
) to complete
the setting.
• The two flash units must be set to the same channel,
otherwise the separated flash unit will not discharge.
(Photographing)
3
Confirm that both flash units are fully charged, and take the
photograph.
A lamp on the separated flash unit will blink.
Wireless mode (SLAVE)
2
AF360FZ_540FGZ.book Page 44 Friday, December 20, 2013 6:11 PM