285
Ap
pen
di
x
10
Troubleshooting
In rare cases, the camera may not operate correctly due to static
electricity. This can be remedied by taking the battery out and putting it
back in again. After these procedures are done, if the camera operates
correctly, it does not require any repairs.
We recommend checking the following items before contacting a service
center.
Problem
Cause
Remedy
The camera
does not turn
on
Battery is not
installed
Check if a battery is installed.
Battery is not
installed properly
Check the orientation of battery. Re-insert
battery according to the +/- symbols.
The battery power
is low
Replace with a charged battery or use
the optional AC adapter kit.
The shutter
cannot be
released
The built-in flash
is charging
E
blinks while the built-in flash is
charging. Wait until charging is finished.
There is no
available space on
the SD Memory
Card
Insert an SD Memory Card with available
space or delete unwanted images. (p.75,
Recording
Wait until recording is finished.
The lens aperture
ring is set to a
position other
than
s
Set the lens aperture ring to the
s
position or select [Enable] in
[20. Using Aperture Ring] of the
[
A
Custom Setting 3] menu. (p.276)
K-500.book Page 285 Friday, June 14, 2013 2:29 PM