After use

 - Do not apply any perfumed cosmetics to the areas treated immediately 

after treatment.

 - Do not use deodorant immediately after treating the underarms. Wait 

until any skin redness has disappeared completely.

 - See chapter ‘Preparing for use’, section ‘Tanning advice’ for information 

about sun exposure and artificial tanning.

Cleaning and maintenance

To ensure optimal results and a long life for the appliance, clean the 

appliance before and after each use and, if necessary, also during the 

treatment. The appliance loses its effectiveness if you do not clean it 

properly.
Never clean the appliance or any of its parts under the tap or in the 

dishwasher.
Never use scouring pads, abrasive cleaning agents or aggressive liquids 

such as petrol or acetone to clean the appliance.
Never scratch the light exit window or the metallic frame inside the 

body attachment.
Note: Stop using the appliance when it is no longer possible to clean the light 

exit window or the body attachment. 

 1 

 Switch off the appliance, unplug it and let it cool down.

Note: The light exit window becomes hot during use. Make sure it has cooled 

down before you clean it.

 2 

 To remove the body attachment, grab the projections at the top and 

bottom and pull gently.

 3 

 If necessary, clean the outside of the appliance with the soft cleaning 

cloth supplied with the appliance.

 4 

 Moisten the soft cloth supplied with the appliance with a few drops 

of water and use it to clean the following parts:

 - the light exit window

 - the outside surface of the body attachment

 - the metallic frame inside the body attachment

Make sure that the electronic contacts do not get wet.
Note: If water does not clean effectively, use a few drops of high-percentage 

alcohol to clean the parts mentioned above. 
Note: Make sure you clean the appliance before and after each use and, 

if necessary, also during the treatment according to the instructions in this 

section.

ENGLISH

19