![background image](/i/president/156000/president-jimmy-ii-asc/h/president-jimmy-ii-asc-030.png)
3) CHANNEL SELECTOR ~ BEEP
CHANNEL SELECTOR:
and
on front panel
These buttons allow increasing or decreasing a channel. A «beep» sounds each time
the channel changes if the
BEEP
function is activated.
BEEP
Beep on changing the channel, buttons etc.
Beep
function enable : turn on the power while pressing the
(up) button.
Beep
function disable : turn on the power while pressing the
(down) button.
4) CH9/19 ~ F
CH9/19 BUTTON
Channels 9 and 19 are automatically selected by pressing this button. A push activates
channel 9. A second push activates channel 19. A new push returns to the previous
channel.
F - FREQUENCY BAND SELECTION
(configuration: EU ; PL ; In).
The frequency bands have to be chosen according to the country of use. Don’t use
any other configuration. Some countries need a user’s licence.
See table page 50.
Proceeding:
switch off the transceiver. Keep the key
F
pressed and switch on again.
and the letter corresponding to the configuration are blinking.
- In order to change the configuration, use the
and
keys on front panel.
- When the configuration is selected, press 1 second on the
F
key.
and the letter
corresponding to the configuration are continuously displayed, a beep sounds. At
this point, confirm the selection by switching off the transceiver and then switching
it on again.
See the configurations / frequency bands table at page 47 to 48.
5) DISPLAY
It shows all functions:
The BARGRAPH shows the reception level and the output power level.
6) 6 PIN MICROPHONE PLUG
The plug is located on the front panel of the transceiver and makes the setting of
the equipment into the dashboard easier.
See cabling diagram page 48.
7) PTT
Transmission key, press to transmit a message,
is displayed and release to listen
to an incoming communication.
TOT (Time Out Timer)
If the
PTT
key (
8
) is pressed for more than 5 minutes, channel and
blink, the trans-
mission ends until the
PTT
key (
8
) is released.
ANL FILTER (Automatic Noise Limiter)
The transceiver is equipped with an automatic filter which reduces back ground
noises and some reception interferences.
English
30