8
FRUIT AND VEGETABLE COMPARTMENT
Moisture
control slide
Fruit and vegetable tray
Cover
Partition
1.
You may adjust the moisture of the fruit and vegetable compartment by the moisture control
slide. The slide towards the two sides may increase the moisture, vice versa.
2.
The partition of the fruit and vegetable tray separates the fruit and vegetable compartment
into two parts. You are allowed to adjust it according to the fruit and vegetable types and
quantities to meet a satisfactory need of storage space.
The fruit and vegetable compartment is able to
preserve the water content and freshness of the
fruits and vegetables as it is sealed to prevent cold
air touching the fruits and vegetables.
It is appropriate to the storage of vegetables and
fruits.
Caution:
Tropical fruits, such as banana and pineapple are not recommended.
The temperature is adjusted by the slide under the
control of temperature controller. The signs,
strong , mediate and weak , on the knob receptively
indicate the inside temperature condition. Under the
same circumstance, stronger the knob reflects, lower
the inside temperature is. Close
means stopping
working.
In normal use, adjust the slide at the mediate and
change it to the location between weak and mediate
if any hot weather. If the room temperature is below
15
, then open the season switch and change the
slide to the location between mediate and strong .
If the room temperature is below 10
, it's a must to
locate the slide at the Winter area.
MECHANICAL TEMPERATURE ADJUSTMENT
HOW TO USE
Lift the shelf head and pull it out. (Position the
shelf as per the container height)
Refrigerator shelf
Fruit and vegetable tray and cover
Freezer tray
Egg guard and bottle guard
Draw out the fruit and vegetable tray.
Lift up the cover head to pull it out.
Draw out it till the block, lift the shelf rear and
pull it out.
Lift them up to take them down.
DISASSEMBLING PARTS
Pull out the plug
Turn off the lamp counterclockwise.
Screw on the lamp clockwise.
Lamp parameter: 220V/240V, 15W
CHANGE THE INTERIOR LAMP
Turn off the screw in the lampshade inner wall
hold the lampshade with palm and push forward
to take out the lampshade.
Hang on the hook under the cover and turn
upward to push into the upper hook. Afterwards,
refit the screw into the lampshade interior wall.
5
F
F
O
W
IN
TE
R
¹Ø
Season switch
Temperature adjustment
Season switch
Temperature adjustment
¹Ø
W
IN
TE
R
CO
LD
MID
F
F
O
WARM
RL24MB
RL26MB
