29

INST

ALLA

TION INSTR

UCTIONS

INSTALLING THE WATER DISPENSER LINE

COMPRESSOR COVER OF
REFRIGERATOR

- Remove the compressor cover of the refrigerator.

- Connect the water line to the valve, as shown in the figure.

- When connected, check if there is any leakage.

If any, repeat the connection.

- Reattach the compressor cover of the refrigerator.

CONNECTION NUT

WATER LINE

CLIP A

WATER LINE

- Using clip ”A”, fix the water line to the wallor (the back of

refrigerator).

- When the water line is secure, make sure whether the

water line is not excessively bent, pinched or squashed.

Complete the installation of the water supply line.

- Power on the refrigerator and press the lever on the right of the 

dispenser until water runs out through the water line and all air has been empty.

- At this time, check for any possible leakages at the join point in the water line.

After securing the water line, move the refrigerator to the required location.

Once the refrigerator is in position, do not move possibly.

Install the water filter.

Connect the water line to the refrigerator.

SEPARATION 

OF RED CAP

STICKER

(MONTH INDICATION)

COVER FILTER

ALIGN THE INDICATION MARK
WITH LOCK POSITION.

Caution

Please check if the indication line aligns with the lock position.

-  As shown, separate the fixed cap in the refrigerator by rotating 

it counterclockwise.

Remove the water filter from the box and put a month indicator 

sticker on the filter as shown.

-  Write the month you installed the filter on the label.

EX) If the water filter was installed in March, put “MAR”

-  Remove the protective cap then position and insert the filter as shown,

-  Slowly turn the water filter clockwise 90º to align the indication mark on the 

cover, locking the filter in postion. Do not overtighten.

Secure the water line.