•
Plug the power cord built into the active speaker into a mains outlet.
•
Adjust the volume level to the minimum by turning the volume control knob
a
counter-
clockwise until it stops.
•
Turn on the MSS power supply with the power switch
e
on the active speaker rear panel, the power
LED
d
lights up.
•
Turn on your audio source.
•
Adjust the volume level by turning the volume control knob
a
. If you turn the knob clockwise, the
volume level increases, if you turn it counterclockwise, it reduces.
•
Adjust the treble level by turning the treble control knob
b
. If you turn the knob clockwise, the
volume level increases, if you turn it counterclockwise, it reduces.
•
Plug the headphones into the headphone jack
c
(see Fig. 1).
Notes:
• If the MSS is left unused for a long period of time, please mind to switch off the power
with the power switch on the rear panel of the active speaker and unplug it.
• To improve the sound quality, use the Line-Out port of your sound card.
6. TROUBLESHOOTING
If none of the above methods can solve the problem, please seek professional advice at your
nearest service center. Never attempt to repair the product yourself.
Problem
The MSS does not
turn on.
No sound.
There is too quiet
sound of speakers.
Distortion of
sound.
Cause
The MSS isn’t connected to a mains outlet.
The power switch is o
Ԛ
.
The volume level is set at minimum value.
Improperly connected audio source.
The volume level is set at minimum value.
Large amplitude of the input signal.
Solution
Check the connection.
Turn on the switch.
Adjust the volume control knob.
Connect audio source correctly.
Adjust the volume control knob.
Turn down the source volume
and the MSS volume.
16
ENG
2.0 Multimedia Speaker System
