![background image](/i/tec/155357/tec-apo160fl/h/tec-apo160fl-003.png)
OVERVIEW
This manual has been written to help you enjoy using your TEC APO 160 refractor.
The APO 160 has number of features that in a given combination are rarely found in one scope:
Precision apochromatic objective with modern coating that makes lenses almost invisible.
Retractable Dew Shield. Light weight tube assembly. FeatherTouch 360° rotatable focuser with coarse and
fine focusing. Collet type eyepiece holder. Line of accessories, including: Precision tube rings with adjustable
latches, Dovetail plate (same width and fit as Losmandy plates), Finder bracket with new principle of finder
adjustment with two thumb screws only.
ALL PARTS OF THE TELESCOPE, INCLUDING: OPTICS, COATINGS, ETC. ARE MADE IN THE USA.
GETTING TO KNOW YOUR TELESCOPE
The parts of the telescope and their functions are identified and described below.
1 Front Cover. - black anodized mashined Aluminum with
push-pull spring loaded latches. It protects the optics and holds
the dew shield during transportation.
2 Retractable Sliding Dew Shield. This feature makes the OTA
shorter for handling and transportation. The open end of the
shield is rounded to improve aerodynamics of the front end of
telescope. Rounded edge creates less turbulence compared to
straight cut baffles.
3 Shield flange. It holds the shield with four 4-40 screws.
4 Tube assembly. The tube interior is coated with a special
light absorbent coating and has 4 sharp edged baffles, which
block internal reflections.
5 OTA Focusing Mounting Flange.
6 Focuser.
See following Instructions written by Detlef
Schmidt (Starlight Instruments Inc.).
The focuser’s tube is coated inside with the same special coat-
ing as the tube assembly.
7 Plug. It is a small part that keeps the focuser end closed.
1
2
3
4
6
5
7
2
To remove cover put thumb
and index fingers into the
sliding latches and move
them in the shown directions.