![background image](/i/timberk/100414/timberk-blanco-ext-bc/h/timberk-blanco-ext-bc-006.png)
www.timberk.com • electric humidifier
6
9. TROUBLESHOOTING
• Always unplug the unit before removing the water tank.
• Do not touch the water in the base during operation!
• Caution-risk of electric shock and damage of the product!
• Switch off the appliance and unplug it from the socket before cleaning it.
Clean the water tank and the base regularly. Use water only, no detergents.
8. CLEANING AND MAINTENANCE
The unit’s scope of delivery includes 1 filter cartridge with balls out of
mineral stone, installed on the water tank cap with the valve, 1 mini of
mineral filter (in set). Filter cartridge with balls out of mineral stone, which
features strong absorbing properties. The filter absorbs elements of heavy
metals such as lead, chrome, mercury, zinc, etc. It decontaminates water
and restores normal pH level.
Filter’s life is 4-6 months, depending on the quality of water used and how
often the unit is used.
If the white deposit appears on things around the humidifier when it is used,
it may have the following causes:
1. Water used contains high amount of magnesium or calcium. You should
use water that was preliminarily treated by a domestic water filter.
2. Residues of calcium and magnesium salts have accumulated inside the
unit. You should clean inner parts of the unit.
3. Steam deposits suspended dust on a surface, contained in the air.
4. The water softening filter properties have deteriorated. You should
replace the water softening filter.
Problem
Possible cause
Remedy
Poor atomizing (insufficient
capacity)
The unit is operating in the minimized
mode (low atomizing frequency)
There is no problem. If you need to switch
to the intensive mode of operation, turn the
regulator handle all the way to the right.
The atomizer is clogged
Clean the atomizer.
Temperature of water in the tank is too low
Set maximum capacity. The humidifier’s
capacity will go up after a while.
No atomizing
The power cord is poorly connected
to the outlet
Connect the power cord into the outlet
carefully
There is white deposit on objects
around the humidifier (salts,
separating out from water)
1. Lime deposits have formed on the
membrane
2. There is a lot of salts in the water used
(calcium and magnesium)
1. Clean the humidifier’s membrane with a
special brush
2. Use filtered water
Steam has an unpleasant odor
Stale water is used
Clean the unit according to the cleaning
and servicing instructions and fill the tank
with fresh water
Remains of stale water or waste have
accumulated in the unit’s case or the
atomizer
Condensate is formed on the
upper part of the humidifier and
on surrounding objects, when it is
operating.
1. High humidification intensity is set.
2. High room humidity and temperature.
Lower the humidification intensity by
turning the on/off and steam outflow
intensity regulator counterclockwise.
Water appears next to the humidifier,
when it is operating.
1. High humidification intensity is set.
2. Lime deposits have formed on the
membrane and in grooves for water (in
the unit’s base).
1. Lower the humidification intensity by
turning the on/off and steam outflow
intensity regulator counterclockwise.
2. Clean the unit according to the cleaning
and servicing instructions.
Water appears next to the humidifier,
when it is not operating
Water tank is leaking
You need to contact an authorized service
center
IMPORTANT!
To avoid deformation or wear of working surfaces,
resulting in decreased atomizing or other malfunctions,
do not use metallic brushes, blades or talc powder
to wipe the atomizer’s surface. The water tank may
leak upon heavy impacts. In case of water leakage,
immediately stop using the unit and contact a service
center. To keep the unit dry, remove water after cleaning
and make sure to dry the unit’s case. Make sure that
there is no water left inside the unit’s case. Prior to a long
break in using the unit, dry its surface and pack it into
a plastic bag, then put it into a box. Store the unit in a
low-humidity room. Storing the unit undried results in
generation of mold
aromatic oils occur fragrance. Aromatic oil supplied is not included.
Press «on / off» on the control panel to turn off the device, and the display
will turn off all the power button, and unplug the appliance.