![background image](/i/toyota/147677/toyota-venza-2011/h/toyota-venza-2011-034.png)
34
1-2. Opening, closing and locking the doors
VENZA_U (OM73012U)
n
Switching the door unlock function
It is possible to set which doors the entry function unlocks.
Turn the “ENGINE START STOP” switch OFF.
When the indicator on the key surface is turned off, press and hold
or
for approximately 5 seconds while pressing
on
the key.
The setting changes each time an operation is performed, as shown below.
(When changing the setting continuously, release the buttons, wait for at least
5 seconds, and repeat
.)
For vehicles equipped with an alarm, unlock the doors using the
wireless remote control and open one of the doors.
If a door is not opened within 60 second after
is pressed, the
doors will be locked again and the alarm will automatically be set.
In case that the alarm is triggered, immediately stop the alarm.
(
→
P. 100)
STEP
1
STEP
2
STEP
2
Multi-information
display
(TFT type only)
Unlocking function
Beep
Hold the driver’s door han-
dle to unlock only the
driver’s door.
Exterior: Beeps three
times
Interior: Pings once
Hold the front passenger’s
door handle to unlock all
doors.
Hold either front door han-
dle to unlock all doors.
Exterior: Beeps twice
Interior: Pings once
STEP
3
OM73012U_VENZA_U.book Page 34 Wednesday, September 28, 2011 8:13 AM