INSTALLATION

Location

The appliance should be installed well away from 
sources of heat such as radiators, boilers, direct 
sunlight etc.

ATTENTION!

It must be possible to disconnect the appliance from 
the mains power supply; the plug must therefore be 
easily accessible after installation.

Shelf holders

Yourappliance is equipped with shelf retainers that 

make it possible to secure the shelves during 

transportation.

To remove them proceed as follows:

Raise the shelf from the back, push it in the direction 
of the arrow until it is freed and remove the retainers.

Electrical connection

Before plugging in, ensure that the voltage and 
frequency shown on the serial number plate 
correspond to your domestic power supply. Voltage 
can vary by ±6% of the rated voltage.

For operation with different voltages, a suitably sized 
auto-transformer must be used.

The appliance must be earthed.

The power supply cable plug is provided with a 
contact for this purpose.

If the domestic power supply socket is not earthed, 
connect the appliance to a separate conductor in 
compliance with current regulations, consulting a 
qualified technician.

The Manufacturer declines all responsibility if

the above safety precautions are not observed.

This appliance complies with the following 

VE.E.C. Directives:

- 87/308 EEC 

of 2/6/87 relative to radio interference

suppression.

- 73/23 EEC 

of 19.2.73 (Low Voltage Directive) and

subsequent modifications;

- 89/336 EEC 

of 3.5.89 (Electromagnetic

Compatibility Directive) and subsequent 
modifications.

10